Follow these steps to clean the laser window lens and galvo mirror: 1. Prepare alcohol...

To lubricate and maintain the moving parts, follow these steps: Remove the L-shaped support bracket...

To replace the coupling, follow these steps: Remove the L-shaped support bracket 1. Turn the...

The “Cut may exceed boundaries” warning usually occurs for the following two reasons: 1. Pattern...

There are two methods to transfer images from a computer to the LaserBurn app: SD...

If the engraved patterns appear blurry, you can address it using the following methods: 1....

The Nano Pro is a high-speed engraving machine, which can cause stuttering if the data...

The zero point of Nano Pro is at the lower left corner. If you want To engrave the file in the center,...

If the machine shows a “Busy/Paused” message, first check whether there is a process currently...

When the laser does not emit light during framing, there are mainly two possible causes:...

If the Z-axis lifting fails, you can replace the column control board by following these...

If the machine suddenly stops during engraving, the main causes are: 1. Data Loss If...