How to focus on Ray5 5W/10W?

1. For the older RAY5 5W/10W
Place the wooden board under the engraving head, loosen the thumbscrew, loosen the laser head adjustment plate, place the focusing column under the laser profile (refer to the figure below), and tighten the thumbscrew.

2. For the new RAY5 5W/10W

Place the wooden board under the laser module, and loosen the 7-shaped hand screw. Move the laser module up and down to align the end face of the profile with the focus plate.

Note that the focus plate is suitable for 5W and 10W laser modules. Please choose the correct focus surface according to the laser module.