How to adjust the laser level

1. Horizontally to the right

(1) Remove the two hand-tightening screws above.

(2) Remove the L-shaped bracket in Figure 1, loosen the screws marked in Figure 2, and tighten the two set screws marked in Figure 3 to a certain position (it cannot be tightened to the full position at once, and you need to keep trying, depending on how much it is off).

(3) After adjustment, tighten the four screws to prevent them from loosening during the process.

2. Front and back horizontal

(1) Remove the two hand-tightening screws above.

(2) Remove the L-shaped bracket in Figure 1, loosen the screws marked in Figure 2, and tighten the two set screws marked in Figure 3 to a certain position (it cannot be tightened to the full position at once, and you need to keep trying, depending on how much it is off).

(3) After adjustment, tighten the four screws to prevent them from loosening during the process.