How to Calibrate and Align the Nano Duo Camera in LightBurn

The Nano Duo comes equipped with a built-in camera that helps users precisely locate materials and designs before engraving.
In LightBurn, if you wish to use the camera feature, it must first be calibrated and aligned. The steps are as follows:

1. Focusing the Nano Duo

Before performing camera calibration and alignment, make sure to focus the Nano Duo properly.
Failure to do so may cause discrepancies between the designed and actual engraving sizes — resulting in engraved patterns appearing larger or smaller than intended.

2. Camera Calibration

Open LightBurn and select "Calibrate Camera Lens" in laser tools. 

Selecting "USB Camera" and "Standard Lens" in the interface, click "Next".

Place the calibration card in the camera view as shown, turn off "Honeycomb check enable", clik "Capture" button, and when "Next" lights up, proceed to the next step. Repeat the same operation multiple times.

Note: A 90-degree rotation of the image is normal and does not affect camera calibration. Position the calibration card according to the diagram; the orientation of the device does not matter.

Until the interface as shown and click "Align Camera", and the lens calibration is completed. 

3. Camera alignment

At the end of section 2, click "Align Camera" ,select "USB Camera", and click "Next".

In addition, you can also enter through "Calibrate Camera Alignment" in lasertools.

Place the wooden board, adjust the focus, set the engraving parameters, click "Frame" to confirm the engraving range is within the wooden board, and then click Engraving, and click "Next" after engraving.

Note: When carving thick materials like wood, refocusing is required.

Click the "Capture Image" button to capture. When the image is clear in the camera view, click "Next". If it is not clear, recapture it or return to the previous step and engraving it again. 

Pan and zoom to find the four corner marks, and double-click in the center of each one as precisely as you can. It is important that you mark the corners in their numbered order(1, 2, 3, 4).

When you have marked all four corners, click "Next" to continue.