Nano Pro: Engraving Stuttering

The Nano Pro is a high-speed engraving machine, which can cause stuttering if the data transmission speed is slower than the engraving speed. To prevent stuttering, you can use the following settings:

Note: Engraving from an SD card will not cause stuttering.

LightBurn

1. Click the relevant button in the top menu bar and enable the Enable GCode Clustering option.

2. Click OK to save.

LaserBurn (PC)

1. Click the relevant button in the top menu bar to open the Machine Settings interface.

2. Enable the Enable GCode Clustering option.

3. Click Save to apply the settings.