Replacing the Motor

Replacing the X-axis or Y-axis motor is similar and not dependent on the machine model. This example uses the Ray5 40W X-axis motor.

1. Unplug the X/Y-axis motor cable. 

2. Loosen the X/Y-axis timing belt.

3. Use a 2.5 mm hex wrench to loosen the four screws and remove the X/Y-axis motor.

4. When installing the new motor, the X-axis motor connector should face left, and the Y-axis motor connector should face backward. Make sure the timing belt is properly seated on the coupling and adjusted to the correct tension, then plug in the motor cable. Motor replacement is complete.