Replacing the X-axis or Y-axis motor follows a similar procedure and is not model-specific. This...

The Ray5 mini and miniS use the same mainboard, and the replacement procedure is similar....

1. Disconnect the laser cable, loosen the M3*14 or L-shaped hand screws, and remove the...

Ray5 mini and miniS use the same type of ribbon cable, and the replacement method...

The failures of laser engraving marks are unclear and may be due to incorrect focus,...

1) Check if the limit cable is loose. If it is loose, tighten the cable. 2) Check...

1) Manually moving the laser position during engraving causes limit triggering. 2) When you click Stop during...

Click File > Open File to add the design to be engraved, and adjust the...

1) Can't find CH340 driver For Windows systems, it needs to right-click the computer and select...

1) Check if the emergency stop switch is pressed. If it is pressed, turn it clockwise...

  ## I. For Windows Systems ### 1. Common Causes & Solutions **1) System Compatibility...

1. Weak Wi-Fi SignalIn LightBurn or LaserGRBL, enter $wifi/listAPs in the console to search for available...